Luna MINI ASM 5-A1 Manual De Instrucciones página 23

• Assemble in the air inlet (Pos. 6) a nipple 1/4" outlet thread.
• Under no circumstances a defective saw or saw blade can be used as it may cause
injuries andmaterial loses.
• Remember that different saw blades with appropriate saw teeth must be selected for
differentworking materials. Use a saw blade with more teeth for treatment of solid
materials and a saw with fewer teeth for treatment of soft materials. Make sure that the
saw blade is correctly assembled and properly secured in the saw blade holder (Pos. 2).
Useonly the saw blades specially designed for use with the air saw.
• Assembly of the saw blade – The tool must always be disconnected from the com-
pressed airsupply. It will help you to secure yourself against pressing the lever (Pos. 4)
and startup of the tool unintentional. Loosen the hexagonal screw (Pos. 4) of the saw
blade holder (Pos. 2). Install the saw blade with its teeth directed upwards or down-
wards, depending on the kind of position that is better suited for the work task to be
done. Press the saw blade in the saw blade holder as far as it goes. Then tighten both
screws of the saw blade holder by use of an appropriate hexagonal spanner.
• Adjustment of the saw guide (Pos. 1). – Unscrew the fixing screws (Pos. 7). Adjust the
sawguide in the position in order to ensure the required cut depth and prevent vibration
and twisting of the saw blade during operation of the tool. The saw guide must always
enclose the saw blade, in order to prolong life time of the saw blade. Then tighten both
screws of the saw blade holder by use of an appropriate hexagonal spanner.
• During operation of the tool, the saw blade must always be directed against the working
mate-rial. In case of operation of the tool in idle running with lifted saw blade, the saw
blade may disunite from the tool and cause injuries or material loses.
• Never press the saw against the working material with greater or less power than
required.Remember that the tool may not be pressed or turned sideward as in that case
the saw blade may lose its efficiency and might easily get broken. The saw blade is
most efficient when it is athwart directed against the working material.
• The air saw can be used in combination with needle files (diameter 3 mm) as well.
In this casethe saw guide (Pos. 1) may not be used and it has to be removed prior
commencement of sawing operations.
• Check air pressure and, if necessary, adjust it so that the tool would operate at the
requiredpressure and rotation per minute. Adjustment of the pressure is performed by
use of the compressor or separately installed pressure regulator and adjustment of the
rotation speed is performed by use of a separately fitted air supply regulator (not includ-
ed in the standard supply). Specification of the tool complies at 6.2 bar pressure.
• Always be careful when using the saw. A negligent attitude towards the tool may cause
dama-ges of the internal parts and housing fractures. It may result in reduction of the
tool efficiency and the tool may loose its value.
Check-out: Lubricating is important in order to reduce noise and vibration level. In case
of continuous use of the tool is should be cleaned and checked at least 2 times a year.
Instructions
23