Publicidad
with this drive. Using the wrong size screws might damage the drive.
Thread the screws in loosely to check their position. Usually two screws are
used on each side.
3. Check to make sure the alignment is correct, and then tighten the screws to
secure the drive. Do not overtighten.
Step 6. Attaching the cables to the drive
Connect the cables to the CD-RW drive as follows:
1. If you want to connect the CD-RW drive to your sound adapter or to the
sound function on your system board, locate the included audio cables and
determine which cable best fits the CD audio-in port on your sound
adapter. Connect one end of the selected audio cable to the CD-RW drive
audio-out connector 1 , and the other end of the cable to your sound
adapter CD audio-in port. Save the other cable in case you use a different
sound adapter in the future.
2. Attach a 40-pin IDE-cable connector 2 to the IDE connector on the drive.
Align the cable so that the color-coded edge is closest to the power cable
connector 3 . Use the IDE cable provided with this option if there is no
cable attached to the IDE port or if there is only one device connector on
the IDE cable. If you use the included IDE cable, attach one end of the
cable to your system board IDE port or to your IDE adapter, and the other
end of the IDE cable to the CD-RW drive.
3. Locate one of the available power cables attached to your computer power
source. Attach the four-pin power cable 3 to the CD-RW drive dc power
connector.
Step 7. Completing the hardware installation
To complete the hardware installation, do the following:
1. Be sure that the drive is securely mounted and the connectors are firmly
attached.
1-8
12x8x32 Internal IDE CD-RW Drive: User's Guide
Publicidad
