Normal Maintenance - Chef'sChoice Diamond Hone 110 Manual De Instrucciones

Ocultar thumbs

Contenido

página de 37

/ 37
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

The blade of a well designed chef's knife is curved continuously from the blade tip to the end

near the handle so that, with a rocking action on a cutting surface, the entire blade length will

cut cleanly. Chef'sChoice

other sharpening methods. If your chef's knife has a heavy bolster near the handle extending

to the edge, a commercial grinder can modify or remove the lower portion of the bolster so the

bolster will not interfere with proper cutting action of the knife.

Chef'sChoice

Professional Model 110 will sharpen the entire cutting edge from tip to bolster

or handle. For this reason, when using paring knives, it is essential to exercise extreme care to

keep fingers away from the incredibly sharp edge near the handle.

The Professional 110 is the ideal sharpener for your favorite sporting and pocket knives. It will

put the same incredibly sharp Trizor

the bolster. See "Suggestions" section.

No lubrication is required for any moving parts, motor, bearing surfaces or sharpening surfaces.

Your sharpener may be cleaned by carefully wiping with a damp cloth. Do not use detergents

or abrasives.

To clean metal dust that may accumulate in the PRE-SHARPENING section, simply remove the

circular plastic plug that is located on the underneath side of the sharpener. Shake out the metal

dust and replace plug. You may wish to do this once every eighteen months with normal usage

or more often with heavy use.

In the event post-warranty service is needed, return your sharpener to the EdgeCraft factory where

the cost of repair can be estimated before the repair is undertaken. Please include your return

address, daytime telephone number and a brief description of the problem or damage on a

separate sheet inside the box. Retain a shipping receipt as evidence of shipment and as your

protection against loss in shipment. Outside the USA, contact your retailer or national distributor.

Assembled in the U.S.A.

This product may be covered by one or more EdgeCraft patents and/or patents pending as marked on the product.

Chef'sChoice

, EdgeCraft

trademarks of EdgeCraft Corporation, Avondale, PA.

Conforms to UL Std. 982 Certified to CAN/CSA Std. C22.2 No. 64

F16

Chef'S KnIVeS and parIng KnIVeS

will sharpen the entire blade uniformly, avoiding a swale common to

SportIng and poCKet KnIVeS

edges on the entire length of these blades from the tip to