Nice HSTT2 Instrucciones Para La Instalación página 5

• "Toggle" memorisation mode: see Table 1 and proceed as follows:
01. Press and hold "Push" (fig. 1) for at least 1 second, then release: the led remains lit.
02. On the control device, perform the procedure as described in: "Action to memorise command";
03. The led turns off for 2 seconds to confirm memorisation. If the device has already been memorised, the led
flashes quickly for approx. 1 second.
04. Within 20 seconds, repeat point 2 to memorise other devices if required; the system exits the program-
ming phase automatically after this time interval.
Note on toggle operation: in the event of a power failure, even brief, the receiver memorises the output status
and restores the latter when the power is restored.
• "Timed" operation mode: this is programmable with 4 different times; see Table 2.
N° times "Push" key is pressed
1
2
3
4
Control device
Keypad
Remote control
Detector (all models)
Control panel
Control panel ((with one of
the 16 radio controls
configured as "PULSE")
Control panel (with one of
the 16 radio controls
configured as "ON-OFF")
To perform memorisation in timed mode, see Table 3 and proceed as follows:
01. Press and hold "Push" (fig. 1) for at least 1 second, then release: the led remains lit.
02. Press the Push key briefly the same number of times as the required timed setting (Table 2): the led flash-
es as envisaged for the specific setting;
03. On the control device, perform the procedure as described in: "Action to memorise command";
04. The led remains lit for 2 seconds to confirm memorisation. If the device has already been memorised, the
led flashes quickly for approx. 1 second.
05. To memorise other devices, repeat point 03 within 20 seconds; when this time elapses, the programming
phase terminates automatically.
4.2 – HSTT2N: device memorisation
HSTT2N has 2 types of interlocked outputs: one for the UP command (▲) of the shutter and one for DOWN
movement (▼).
Activation of the command is "timed"; 4 different work times can be programmed according to the time
required by the shutter to complete the manoeuvre; see Table 4.
ILed signal
1 flash - 2 s pause.
2 flashes - 2 s pause.
3 flashes - 2 s pause.
4 flashes - 2 s pause.
Table 3 - Timed memorisation mode on HSTT2L
Receiver output
Key : attiva l'uscita temporizzata
Key : attiva l'usicta temporizzata
Key (if configured as command key):
activates the timed output
On each alarm signal: activates the
timed output
In alarm status: activates the timed output
On: led ON - off: led OFF
Remote commands "On" or "Off": acti-
vates the timed output
Not used
Table 2
Timed mode
1 second
30 seconds
1 minute
3 minutes
Action to memorise command
Press for 10 seconds
Press for 10 seconds
Press for 10 seconds
Insert the battery in the detector
Disarm the control panel
(with a suitable device)
On the control panel, perform the radio
control configuration procedure;
select "PULSE" and press OK
English – 3