Rofis MR30 Manual De Usuario página 3

When using for the first time, please unscrew the
tail cap and remove the plastic insulation tab from
the flashlight.
Please charge the flashlight battery completely
before using for the first time. Battery performance
will be better if it is fully charged.
Installing the Battery
Unscrew the tail cap and insert the battery inside
the flashlight with the battery's positive terminal
facing inwards and the negative terminal facing the
flashlight tail cap. After inserting the battery, tighten
the tail cap to complete installation.
Charging
1) Before charging, ensure that the battery is
correctly loaded into the flashlight, and the tail of
the flashlight has been tightened;
2) Insert the charging cable Micro USB port into
the flashlight charging port, then insert the
charging cable USB port into the power port to
recharge. Charging light red indicates charging,
green indicates charging has been completed. The
flashlight can only turn on medium mode while
charging.
II Operation Instructions
Switching on/off
Press the button to switch on/off the flashlight.
When switched on, the flashlight turns on at the
last used Memory Brightness mode. Memory
-04-
Brightness modes include: Low brightness,
Medium brightness and High brightness.
Brightness Changes
When the main lamp or the side lamp is on, press
and hold the switch for more than 1 second and
hold it for a long time. The flashlight goes into the
"low - medium - high" circularly. After letting out, it
will enter into the currently selected brightness
level.
Turbo Mode
With flashlight on/off, double-click the button
quickly, the flashlight enters into the Turbo mode.
Location Mode
With flashlight off, press and hold the switch button
for 3 seconds and open the flashlight location
mode, red light flashing at a fixed frequency.
Lock and Unlock
Turn off the switch, press the switch button for
more than 4 seconds, the flashlight flashes twice,
the flashlight into the lock state; lock state click the
button, the red indicator light reminds the flashlight
locked status. Press the switch button for 3
seconds, the main light into low-mode, flashlight in
unlock status.
Special Mode
1)Strobe: Under any status, press the button
rapidly and continuously to enter the Strobe mode.
2)Strobe-SOS mode: After entering the Strobe
mode, long press the button for more than 1
-05-