Battery Indicators - Master & Dynamic MW07 Manual Del Usuario

BATTERY INDICATORS

Your earphones hold 3.5 hours of listening time when fully charged. The charging
case holds an additional three full charges for your earphones. We recommend
placing your earphones inside the case when they are not in use, to ensure they
are charged to the fullest each time you begin to use them.
When you place the earphones inside the charging case and close the lid, the
earphones and case battery status will display after three seconds. The LED
indicators will display as amber before displaying your battery level status.
To charge the case, plug one end of the USB-C cable into the back of the case and
plug the other end into a power source. If you do not have a USB-C power source
you can use our supplied USB-C to USB-A adapter to use a USB-A power source.
Case charges to 50% in 15min;
100% in 40min
CASE
Full
Med
Low
EARPHONES
PAIRING
MULTI-FUNCTION
BUTTON
PULSING
INDICATOR LIGHT Right
The first time you take your earphones out of the case they will enter
pairing mode. The indicator light will slowly pulse. Access Bluetooth
settings on your source device, locate MW07 and connect. The light will
stop flashing and you will hear a tone to confirm successful pairing.
If you wish to pair to a different device, long press the button on the
right earphone while it is out of your ear until you see the indicator light
slowly pulse. You may then repeat the pairing process above.
CHARGING PADS
PROXIMITY
SENSOR
Left
4