EGO ST1530E Manual Del Operador página 12

EN
PROBLEM
Trimmer head will not
advance line.
Grass wraps around
trimmer head and
motor housing.
Cracks on the trimmer
head or the lower cover
assembly comes loose
from upper cover.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.
12
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1530E
CAUSE
◾
The motor shaft or trimmer head
is bound with grass.
◾
There is not enough line on the
spool.
◾
The trimmer head is dirty.
◾
The line is tangled on the spool.
◾
The line is too short.
◾
Cutting tall grass at ground
level.
◾
The trimmer head is worn out.
SOLUTION
◾
Stop the trimmer, remove the battery, and clean
the motor shaft and trimmer head.
◾
Remove the battery and replace the cutting
line; follow the section "LINE REPLACEMENT"
in this manual.
◾
Remove the battery and clean the trimmer
head.
◾
Remove the battery, remove the line from the
trimmer head and rewind; follow the section
"RELOAD THE CUTTING LINE" in this manual.
◾
Remove the battery and pull the lines manually
while alternately pressing down and releasing
the trimmer head.
◾
Cut tall grass from the top down, removing
no more than 20 cm in each pass to prevent
wrapping.
◾
Replace the trimmer head immediately
performed by a qualified service technician.