Troubleshooting - XtremeMac LUNA Manual Del Usuario


To Replace the Battery:
1. The battery door is located on the bottom of the remote control. To open,
hold the remote with the back facing up and squeeze the latch while
pulling out the battery door.
2. Take out current battery and replace with a "CR2025" 3-volt Lithium Cell
battery. The battery door has a "+" symbol to indicate correct placement.
Place the battery with the "+" side of the battery on the same side as this
symbol.
3. Replace the battery door with the "+" of the battery facing up.
Note: Please dispose of batteries properly.
LUNA™ User Manual
LUNA™ User Manual

Troubleshooting

No power
Possible Problem
AC Adapter is not connected to
a wall outlet and/or the power
supply connector is not plugged
into supply jack on the back of
Luna
Wall outlet is not functioning
iPod was docked BEFORE
plugging the AC adapter into the
unit and the wall
No sound from speakers
Possible Problem
Audio source is not selected
Volume is set too low
iPod is not docked correctly
Sound is distorted
Possible Problem
Volume level on Luna is set too
high
Sound source is distorted
Bass and Treble are set too high
Remote Control doesn't work
Possible Problem
Low Battery
Remote Control is not pointed
toward Luna's IR window
Unit gets warm after extended play at high volume
Possible Problem
As with other devices, this is
normal when the unit is played
at loud volumes for an extended
period of time
Solution
Connect the AC adapter into the
jack in the back of Luna labeled
"Power" and then plug the AD
adapter into the wall outlet
Plug another device into the
same outlet to confirm the outlet
is working
Make sure to plug the AC adapter
into Luna and then the wall outlet
before docking your iPod
Solution
Push the left control knob on the
unit to select the audio source
Turn the left control knob to
increase the volume
Remove your iPod from the dock
well and re-dock to make sure it
is properly connected
Solution
Use the left control knob or
remote to lower the volume
If the original source (MP3) is of
poor quality, distortion and noise
are easily noticed with high-
powered speakers
Reset the bass and treble
settings with the reset button on
the remote
Solution
Replace battery
Point the remote toward the IR
window, within 15 feet of the unit
Solution
Lower the volume or turn the unit
off for a short period of time