VDS KEY-9 Manual De Instrucciones página 10

8. Delete the users' pin code
If you forget the multiple pin codes that programmed previously. You can enter
into programming mode and delete all users'pin code for the security.
Steps:
a. Enter programming => one long beep follow to confirm
b. Press(00) end up with (# ) => one long beep and one short beep follow to confirm
c. Now the users' pin code for each channel is factory default setting, other
programmed pin codes are deleted.
d. Keypad exits programming mode
9. Learning signal from transmitter
User can directly enter learning mode to learn the signal from transmitters as
follows:
a. Enter programming => one long beep follow to confirm
b. Press ( 59 ) end up with ( # ), enter learning mode => one short beep follow to
confirm
c. Enter 2 digits of the channel's number which you would like to learn the signal
from transmitter. (Example as 01is for 1st channel), end up with ( # ). =>after one
long beep, green LED indicator lights on.
d. Now the keypad is ready to learn the signal from transmitter. You have to press
the transmitter for programming the signal to keypad within 10 seconds, then the
green LED indicator will go off with one long beep to finish the process.
10.Continuously transmitting 10s
For easy programming the wireless keypad to the receiver or control board, you
can make it to transmit the code continuously for 10s of any of both 2 channels
as follows:
a. Enter programming => one long beep follow to confirm
b. Press(55) end up with (# ) => one short beep follow to confirm
c. Key in 2 digits of the channel number which you want it to transmit and end up
with (# ). (Example "01#" is for transmitting the code of 1st channel)
d. Keypad exits programming mode.
11.Scrambled pin code
In case you are accompanied by the person who might see the pin code while
you key it in, you can scramble your pin code while you key it in. To prevent the
visitors from seeing your pin code.
To key-in a scrambled pin code, you can simply press any digits (0-9) in the
keypad.(except the "*" and "# " keys) as many times as you wish, after you finish
the scrambled digits as you wish, then press the correct 4 digits pin code and end
up with ( # ) . Keypad would automatically disregard all invalid scrambled digits
you have keyed-in and transmit the correct channel after the ( # ) key is pressed.