Product Overview - VDS KEY-9 Manual De Instrucciones

PRODUCT OVERVIEW

Ÿ Power supply: DC 6V ( 4pcs AAA 1.5v dry battery).
Ÿ Touch keyboard: 1-9, *, 0, #.
Ÿ Standby current: 18uA (Sleep mode), 6mA ( working mode).
Ÿ Working current: 28mA ( working mode).
Ÿ Three LED indicator light: Red, Green, Blue.
Ÿ Low battery indication: If the battery is low, keypad would have beep indication
after every signal transmission is made.
Ÿ Anti-vandal alarm. When the keypad is disassembled illegally, the buzzer will
"beep" to alert.
Ÿ 4 digits installer's pin code and 4 digits user's pin code setting.
Ÿ RF learning code function: can learn commonly used fixed code, HCS301
rolling code.
Ÿ Two channels RF 433MHZ transmitting.
Ÿ Scrambled pin code.
Ÿ Keypad buzzer on/off.
Ÿ Keypad back light on/0ff.
Ÿ Keypad security lock.
Ÿ Factory default setting
Ÿ Weatherproof
Operation Instruction
Ÿ When keypad enters programming mode, if the keypad does not receive the
further command within 6s, keypad would exit programming mode
automatically.
Ÿ When misoperating the keypad during programming, you can enter
programming mode again after keypad exits programming mode
automatically.
Ÿ When received the command "*"or "#", keypad would receive the command
then judge the command is correct or not. If it is incorrect command, keypad
would exit programming mode; or it is correct command, keypad would
operate further.
Ÿ When programming, if user key in users' pin code more than 4 digits, the
keypad would recognize it as incorrect operation, then exit programming
mode.
Ÿ When keypad in working mode, if the interval time between inputting each digit
is more than 6s, keypad would ignore the previous digit.
Ÿ if keypad is not learning any code, the red LED indicator would flash 5 times
***If there is no any operation in 20s, keypad would enter standby mode. If
user need to operate keypad when it is in standby mode, then must press any
button on keypad to make it back to working mode.
EN