Toparc 060906 Manual De Instrucciones página 6

STORAGE
- Avoid storing the tool in an area exposed to high humidity. If the tool is left as is, residual moisture inside the tool can cause rust.
- Before storing and after use, apply a little oil to the air inlet of the tool and operate it for a short time.
INSTALLATION - PRODUCT OPERATION
APPLICATIONS
• Finishing carts and metal products.
• Automotive body finish
• Welded surface finish
• Finishing before painting.
• Finishing of cabinets and steel furniture.
START
- The compressed air network must be perfectly purged and adapted to the consumption of the tool. A pressure-reducer and lubricator filter (except
for tools provided without lubrication) of appropriate size must be installed at a maximum distance of 10 metres from the tool. Its regulation pressure
must be set at 7.5 bar and the special oil flow rate for tools to be lubricated must be about 1 drop of oil every 30 seconds for an air flow rate of 100
litres/mm. Be careful, the air consumption of your tool must be higher than the minimum priming rate of your lubricator. A shut-off valve must be
placed upstream.
- The connection between this filter-regulator-lubricator unit and the tool is made with a special «compressed air» hose made of rubber or PVC with
a maximum length of 10 metres and an internal diameter of at least 8 mm for tools with a 1/4" supply connection and 12 mm for 3/8" connections.
It must be equipped with an automatic or semi-automatic closing connection close to the tool, for easy disconnection.
USE OF THE SYSTEM
- Only use accessories in perfect condition that correspond to the characteristics of the tool.
- Avoid running the tool empty. If this is the case, after a long period of use, make sure that no accessories are attached to the tool. It is essential
to disconnect the tool for the installation of accessories. Check that they are perfectly fixed before connecting the tool.
- Regularly inspect the condition of the supply piping. In the event of damage or leaks, proceed to immediate repair. A broken pipe can cause
serious injury. Periodically check lubricator levels, filter and pipe purging.
MAINTENANCE
- At the beginning of the day and before a long shutdown period, introduce a few drops of special oil directly into the intake port. Do not use flam-
mable liquids such as gasoline and diesel.
- Regularly check the condition of the regulating filter and the oil level in the lubricator of the air system.
- Ensure that the supply connections, piping and accessories are in perfect condition. Regularly drain the compressor pipes and tank. Don't forget
your probation deadline.
- Only original parts available from the supplier may be used for tool maintenance.
- JBDC cannot be held responsible for changes to tools and failure to comply with general safety rules regarding the use of compressed air.
Quick connection
0.5 m
6
SANDER BELT
Filter regulator
10 m max.
lubricator
Purge
EN
Slope
Valve
Compressor