Velleman VISP2 Manual De Instrucciones

VISP2 – INDOOR CAMERA PAN-TILT MOTOR 24V AC
1. Introduction
Thank you for buying the VISP2! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, don't install or use it and contact your dealer.
2. Installation & Maintenance
Install the unit on a wall bracket by means of the 2 included stainless steel M6x15 screws. Secure the VISP2 to the
wall bracket by fastening the screws from the bottom of the wall bracket into the unit.
The VISP2 requires no lubrication or maintenance for the life of the unit.
3. Wiring
Compose the interconnecting cable in accordance with the figure below for proper operation.
1. COMMON (red)
2. AC24V/AUTO (black)
3. TILT DOWN (blue)
4. TILT UP (yellow)
5. PAN RIGHT (green)
6. PAN LEFT (white)
Inverted Mounting: when the unit is mounted in the inverted position, the left-right directions are reversed for manual
operation. This must be corrected when wiring the cable between control unit and the VISP2. Simply reverse the
leads going to terminals 5 and 6.
4. Adjusting Limit Stops
1. Camera Mounting Plate
2. Limit switch
3. Right/left pan limit stop
4. Connection to control (VSCP1)
When the cable is installed and unit has been mounted, plug the control unit into
AC 24V source. Make sure the auto switch is in the OFF position. Adjust the pan
limit stops by taking them off and putting them where you want them to be.
5. Specifications
Angular travel
Limited Stop
Speed
Load Rating
Input Voltage
Power Consumption
Cable Requirement
Operating Temperature
Construction
Finish
Dimensions
Weight
The information in this manual is subject to change without prior notice.
VISP2
Pan: 355° / Tilt: ± 100°
Externally adjustable
Pan/tilt: 5° / second
7 kg
24Vac
7W
Six-conductor, unshielded
-5°C to + 60°C
plastic
beige
179 x 115 x 180mm
1.6kg
- 1 - VELLEMAN