Weather Station; External Sensor - Trevi ME 3P20 RC Manual Del Usuario

ME 3P20 RC
DESCRIPTION OF CONTROL
A1. RCC radio control icon
A2. External temperature
A3. MAX / MIN memory
A4. External sensor signal icon
A5. External sensor transmission channel
A6. External humidity
A7. External sensor low battery indication
A8. Weather forecast
A9. Internal humidity
A10. Internal temperature
A11. Weather station low battery indication
A12. Daters
A13. Time zone / Time zone
A14. Active alarm icon
A15. Clock / Alarm Time
B1. SET / AL SET button
B2. UP / CH button
B3. MEM key
B4. BARO button
B5. DOWN / RCC button
B6. C / F / BL key
B7. RST button
B8. 5V 1A power connector
B9. 2x 1.5V AAA battery compartment (batteries not supplied)
C1. Hole for wall installation
C2. Operating indicator LED
C3. 2x 1.5V AAA battery compartment (batteries not supplied)
C4. Transmission channel selector
C5. TX key, data transmission

WEATHER STATION

Open the battery compartment (B9) on the back of the appliance and insert two "AAA" size batteries observing the indicated
polarities.
Alternatively, insert the socket of the external power supply into socket B8, insert the power supply into a mains socket.

EXTERNAL SENSOR

Open the battery compartment (C3) on the back of the appliance, and insert two "AAA" size batteries observing the indicated
polarities.
Note: the display of the A7 or A11 icons indicates that the batteries of the external sensor or weather station are low.
EXTERNAL SENSOR SETUP
This weather station is set up to communicate with three external sensors. One of these is supplied with the appliance, the
remaining two are optional.
1. Power the weather station as described in the paragraph "WEATHER STATION".
2. Insert the batteries in the external sensor, place the selector (C4) on the desired transmission channel (1, 2 or 3). The
data will be automatically transmitted to the weather station.
3. Press the UP / CH (B2) button repeatedly to select the channel set on the external sensor. In sequence, channel 1, channel
2, channel 3 or the sequential display of the 3 channels (rotating arrow icon) is selected. If the signal is not received,
the character is shown on the display.
Note: in case of lack of communication between the weather station and the external sensor it is necessary to press the UP
key (B2) for a long time until the signal reception icon appears on the display from the external sensor. It is then necessary
to wait a few minutes for the connection to be made. Alternatively, it is necessary to repeat steps 1 to 3 described above.
Note: Position the weather station away from devices that generate magnetic fields such as mobile phones, televisions, etc.
4
English