TEMPUR North Manual Del Usuario página 5

Assembly Guide to your North™
ORIGINAL INSTRUCTIONS
Tools are required to assemble your product.
For a safe assembly, we do not advise assembling on your own. There are a minimum 2 persons required
for a safe assembly.
CAUTION
• The assembly instructions must be followed closely in order to install the bed system successfully,
safely and to minimize the risk of personal injuries and damaging of the product.
• Inspect all cables and housings prior to installation for any damage. In case of damage, the units must
not be used and are to be exchanged immediately through your supplier or sales agent.
• Electrical components should be connected or disconnected only when the power supply cord is
unplugged.
• There is a delay after the supply voltage is applied before the device turns on. Wait at least two
seconds before beginning the commissioning.
IMPORTANT
Before installing the legs of your North™ Bed, please read the following and refer to image below:
If you intend to use your North™ bed as the below, then it is IMPORTANT that the legs are placed in
Position 1 furthest to the edge of the bed.
• A single bed with four legs
• A double bed without support legs
• NO headboard
16668_TEMPUR_North_Assembly_Guide_EU.indd 3 16668_TEMPUR_North_Assembly_Guide_EU.indd 3
EN
3
19/12/2019 15.35 19/12/2019 15.35