Kobalt KXCS 124B-03 Manual De Instrucciones página 18

OPERATING INSTRUCTIONS
WARNING
• Attempting a bevel cut without having the bevel-locking knob (O) securely locked in place
can result in serious injury.
d. Hold the saw firmly with both hands, as shown.
e. Rest the front edge of the base on the workpiece without touching the blade to the
workpiece.
f. Start the saw and allow the blade to reach full speed. Guide the saw into the workpiece
and make the cut.
g. Release the trigger switch and allow the blade to come to a complete stop.
h. Lift the saw from the workpiece.
14. Pocket Cutting
WARNING
• Always adjust the bevel setting to 0°before
making a pocket cut. Attempting a pocket cut at
any other setting can result in loss of control of
the saw and possible serious injury.
a. Adjust the bevel to 0°and tighten the bevel-
locking knob (O).
b. Set the blade to the correct blade cutting
depth.
c. Swing the lower blade guard (G) up using the
blade-guard lever (F).
d. Hold the lower blade guard in place with the
blade-guard lever.
e. Rest the front of the base shoe (U) against the workpiece, with the rear of it raised so that
the blade does not touch the workpiece.
f. Press the lock-off button (C) and depress the trigger switch (A) to start the saw.
g. Allow the blade to reach full speed, then guide the saw into the workpiece and make the
cut.
h. Release the trigger switch and allow the blade to come to a complete stop.
i. Lift the saw from the workpiece.
WARNING
• Always cut in a forward direction when pocket cutting. Cutting in the reverse direction could
cause the saw to climb up on the workpiece and kick back toward the operator.
• As the blade starts cutting the material, release the blade-guard lever immediately. When
the foot of the guard rests flat on the surface being cut, proceed cutting in a forward
direction to the end of the cut.
• Never tie the lower blade guard in a raised position. Leaving the blade exposed could lead
to serious injury.
14
F
18
O
U