Guide - GE 26925A Guia Del Usuario

T
ROUBLESHOOTING
Problem
Cannot hear the
Page alert tone
Range is shorter
than normal
Battery will not hold a
charge OR is fully charged
and the BAT LOW lights
BAT LOW light stays on
Memory Dialing
doesn't work
Unit locks up
no communication
between the base
and the handset
26
G
UIDE
Solution
• Set the PWR switch on the handset to ON (the far left
position).
• Press the CHAN button during the conversation to select a
new channel.
• Position the base antenna upward.
• Be sure you are sufficiently charging the battery. When the
battery has been charged for 12 hours, you can expect
approximately 4 hours of talk time.
• Check to be sure battery contacts on both the handset and
the base are making contact and are clean; free of dirt or lint.
• When the handset is placed in the base, check that the base
CHARGE light is on.
• Place handset in base for 10 seconds to reset the phone. If
that doesn't work, charge battery for 12 hours.
• Did you program the memory location keys correctly?
• Did you follow proper dialing sequence?
• Make sure T/P switch is correctly set.
• If the phone still does not work, disconnect the power cord
and remove the battery pack. Then reconnect the power cord
and reinstall the battery pack. Place handset in the base for
10 seconds to allow it to reinitialize.
• If a power outage occurs while the handset is away from the
base, the handset must be returned to the base when the
power returns.
(
CONTINUED
)