Product Specification; Safety Instructions - LUND 67840 Manual De Instrucciones

GB

PRODUCT SPECIFICATION

The low-speed juice squeezer is used to extract juice from fruit and vegetables using a special auger. Thanks to the slow rotation,
fruit and vegetables retain more taste and vitamins than in the case of high speed squeezers. The drained pulp and the squeezed
juice are placed in separate containers, so that the juice is ready to drink immediately after the machine is used. The product is
designed for domestic use only and may not be used in commercial applications. The correct, reliable, and safe operation of the
device depends on its proper use, which entails:
Reading and keeping the entire manual before the fi rst use of the device.
The supplier shall not be held liable for any damage resulting from failure to observe the safety regulations and recommendations
specifi ed in this manual.
ACCESSORIES
The product is delivered complete, but requires carrying out a number of preliminary actions described in further sections of the
manual. Juice and pulp containers are supplied with the product. Proper container spacing is required before use.

SAFETY INSTRUCTIONS

CAUTION! Read all of the following instructions. Failure to do so may result in electric shock, fi re, or injury.
FOLLOW THE INSTRUCTIONS BELOW
Do not use the product in an explosive environment containing fl ammable liquids, gases, or vapours.
Set the device on fl at, even, and hard surfaces. If the device is equipped with rubber feet or suction cups, select a surface type
such that the feet or pads prevent the device from moving during use.
Do not place the device near any heat or fi re sources.
Connect the device only to the power network with the voltage and frequency indicated on the nameplate of the device. The device
must be plugged into an outlet with a protective contact.
The plug of the power cord must match the power socket. Do not modify the plug. Do not use any power adapters to adapt the
plug to the socket. An unmodifi ed plug, which matches the socket, reduces the risk of an electric shock.
After each application, unplug the power cord from the power socket. Do not disconnect the plug by pulling on the cable. Pull the
plug out of the socket, always grasping it by its housing.
Avoid direct contact with grounded surfaces such as piping, radiators and refrigerators. Grounding of the body increases the risk
of an electric shock.
The device is intended for indoor use only. Do not expose the device to any precipitation or moisture. If water and moisture enters
the device, the risk of an electric shock is signifi cantly increased. Do not immerse the product in water or any other liquid. Do not
pour water into the product bowl during operation.
Do not overload the power cord. Do not use the power cord to carry, connect, or disconnect the plug from the power socket. Avoid
any contact between the power cord and heat sources, oil, sharp edges, and moving parts. Damage to the power cord increases
the risk of an electric shock. If the power cord is damaged (e.g. it is cut, its insulation is melted), immediately unplug it from the
wall socket, and return it to an authorised service facility. It is not allowed to use the product with a damaged power cord. It is not
allowed to have the power cord repaired. It must be changed for a new one at an authorized service centre. When using exten-
sion cords, use extension cords with power parameters such as those shown on the device's nameplate. The cross-section of
the extension wires shall not be less than the cross-section of the wires of the power cord of the device. This should be checked
on the insulation of the power cord and the extension cord or contact the manufacturer of the device and/or the extension cord.
Do not use an extruder with a damaged auger, fi lter cartridge or frame. If you notice any damage to any part of the device, you
must discontinue using it. In this case, the device must be taken to an authorised service centre or replaced by yourself, if this is
permitted by the user's manual.
Turn off the device and unplug the power cord from the wall socket before you start any work on replacing, cleaning, or adjusting
moving parts.
This device may be used by children of at least 8 years of age and by persons with reduced physical, mental abilities and persons
with no experience or knowledge of the device, if supervised or instructed on its safe use so that the risks associated with it were
understandable. Children should not play with the device. Children should not be allowed to clean or maintain the product without
supervision.
The device is intended for home use only. It is recommended not to exceed 30 minutes of continuous operation, after which the
device should be left for about 30 minutes to cool down. During cool-down, unplug the power cord from the power socket.
O R I G I N A L I N S T R U C T I O N S
10