Problem Solving - Philips SBCSC450 Modo De Empleo

ENGLISH
12
Problem
Power light does not
light up
Small Parent Unit
batteries do not
charge
No sound
Power light lights
up red
Interference or
poor reception
Pick-up from
another baby
monitor

Problem solving

Possible cause
Parent Unit(s): Unit(s) not turned on.
Power adapter(s) not plugged in or
batteries are exhausted.
Baby Unit: Unit is not turned on.
Power adapter is not plugged in or
batteries are exhausted.
Battery life is at an end.
Volume on Parent Unit(s) is set
too low.
Microphone sensitivity on Baby Unit
is set too low.
Batteries are low or empty.
Mobile or cordless phones too close
to the baby monitor.
Parent Unit(s) too close to a window.
Both systems are operating on the
same frequency.
Solution
Turn the Volume control on/off switch
control (14, 25) downwards.
Plug in power adapter(s) (17, 23) or
replace/recharge batteries.
Connect BU to mains supply/insert
batteries and push power button (3).
Plug in power adapter (7) or replace
batteries.
Connect charging base (22) to mains,
power. Replace battery pack.
Turn the Volume control on/off switch
control (14, 25) downwards.
Adjust the microphone sensitivity of the
Baby Unit, using the Microphone sensitivity
control (8).
Big Parent Unit -replace batteries or
connect to mains power.
Small Parent Unit: - recharge battery pack.
Baby Unit: - replace batteries or
connect to mains power.
Move phones away from the units.
Move Parent Unit(s) closer to Baby Unit.
Move Parent Unit(s) away from windows.
Switch channels.