Bimar HFH804 Folleto De Instrucciones página 13

 WARNING: this heater is not equipped with a device to control
the room temperature. Do not use this heater in small rooms
when they are occupied by person not capable of leaving the
room on their own, unless constant supervision is provided.
 If fixed in a bathroom shall state that the heater is
to be installed so that switches and other controls cannot be
touched by a person in the bath or shower.
 Do not use the appliance with a timer or a programmer or with a
system that can switch on the appliance automatically, to avoid
risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly. Check that no other high absorption
appliances are connected to the same power source.
INSTALLATION
 After removing the packing materials, check the integrity of the heater; if you are
unsure, do not use it and ask for qualified professional help. The packing materials
(plastic bags, polystyrene foam, nails, etc.) must be kept out the reach of children
because they are potential sources of danger.
 Before connecting the appliance, check that the voltage shown on the data plate
matches that of your electricity. In the event of incompatibility between the electric
outlet and the plug of the heater, have the outlet replaced with another more
suitable type by professionally qualified personnel, who will make sure that the
section of the wires of the outlet is appropriate for the absorbed power of the
heater (10A). Check that the mains are not connected equipment; high absorption
to prevent overloading and fire risks. In general, the use of adapters or extension
cords is not recommended; if their use is indispensable, they must conform to
existing safety standards and their current capacity (amperes) must not be less that
the maximum of the heater.Attention: before use the appliance remove the
detachable coupon to stick the handle.
 Before each use, verify that the heater is in good condition and that the electrical
cord is not damaged: in the case of doubt, ask for professionally qualified help.
 Make sure that the cable is correctly positioned and that it is not in contact with hot
parts or sharp edges, nor wrapped around the device or twisted.
 The appliance must not be positioned immediately under a socket.
 The power socket must be easy to reach so the plug can be removed quickly in case
of emergency.
 Position the fan heater far from other sources of heat, inflammable materials
(curtains, carpets, etc.), inflammable gases or explosive materials (spray cans) and
from materials that can deform on exposure to heat. Make sure that there is 100 cm
of free space in front of the fan heater and 40 cm on the sides. Do not use the
heater in the immediate vicinity of a bathtub, shower or swimming pool (to avoid
13/45