Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTION SHEET FOR FEDERAL MODEL BPL26ST BATTERY POWERED
Failure to follow all safety precautions and instructions may result in property damage, serious
injury, or death to you or others.
The use of a warning device does not eliminate the hazard nor the users responsibilities. Carefully
evaluate your hazard condition and take all appropriate actions.
Follow all instructions shipped with this product. This device is to be installed by a trained
electrician who is thoroughly familiar with the National Electrical Code and will follow the NEC
Guidelines as well as local codes.
The selection of the mounting location for the device, its controls and the routing of the wiring is to
be accomplished under the direction of the facilities engineer and the safety engineer. In addition,
listed below are some other important safety instructions and precautions you should follow:
• Read and understand all instructions before installing or operating this equipment.
• Do not connect this light to the system when power is on.
• After installation, test the light system to ensure that it is operating properly.
• After testing is complete, provide a copy of this instruction sheet to all operating personnel.
• Establish a procedure to routinely check the light system for proper activation and operation.
A. Unpacking.
After unpacking the Model BPL26ST, examine it for damage that may have occurred in transit. If
the equipment has been damaged, do not attempt to install or operate it. File a claim immediately
with the carrier stating the extent of the damage. Carefully check all envelopes, shipping labels
and tags before removing or destroying them.
B. Mounting.
The Model BPL26ST is designed for portable use. It comes with a magnetic mounting base.
The holding power of the magnetic mount is dependent upon surface finish, surface flatness, and
thickness of the steel mounting surface. Therefore, to establish a good magnetic coupling:
• Keep the mounting surface and magnet clean, dry, and free of foreign particles that prevent good
surface contact.
• Ensure that mounting surface is flat.
C. Service and Operation.
1. Operation.
Press the black rubber switch cover on the side of the battery housing until a click is heard. The
light will begin to flash. Repeating the above procedure will shut the light off.
2. Battery Replacement.
Open the battery housing by removing the 1/2-inch bolt and neoprene washer. Bend the upper
housing out slightly on each side and pull the lower housing out. Install the batteries as shown
in figure 1 by standing the batteries in the bottom housing with the spring terminals aligned
WARNING STROBE
SAFETY NOTICES
WARNING
SAFETY MESSAGE TO INSTALLERS
Note
-1-
Publicidad
