Toro 51581 Manual Del Operador página 8

Operation
Important:
This appliance is intended for outdoor,
residential use only. Do not use it indoors or for commercial
or industrial purposes.
Connecting to a Power
Source
The power supply you use with this appliance should be a
residential current device (RCD) with a tripping current of not
more than 30 mA. Use only a CE approved extension cord
recommended for outdoor use. Do not change the appliance or
extension cord plug in any way.
WARNING
If you do not fully seat the extension cord on the
inlet plug, or if the plug and cord do not fit firmly, the
loose plug could lead to overheating and cause a fire,
possibly burning you or others.
•
Ensure that you fully seat the cord on the plug.
•
Check the connection regularly to ensure that the
cord is firmly attached.
•
Do not use a worn-out or loose extension cord.
Extension Cord Length
30 m
45 m
Note:
Do not use an extension cord over 45 m.
Important:
Check the extension cord frequently during
use for holes or cracks in the insulation. Do not use a
damaged cord. Do not run the cord through standing water
or wet grass.
Secure the extension cord to the appliance using the molded in
cord-lock feature.
1. Extension cord
Minimum Wire Gage
1.0 mm 2
2.0 mm 2
g224197
2. Cord lock
Starting/Stopping/Adjusting
the Air Speed
Using the Concentrator
Nozzle Accessory
Install the power and concentrator nozzles into the blower tube to
help reach into narrow spaces or to remove matted debris from
hard surfaces.
1. Blower tube
2. Power nozzle
Using the Oscillator Nozzle
Accessory
Install the oscillator nozzle onto the blower tube to save time
clearing hardscapes. It automatically sweeps the back-and-forth,
creating a wider blowing path with less side-to-side wrist
movement.
Note:
Remove the oscillator nozzle before using the cord wrap
to store the blower.
6
g025396
g025397
3. Concentrator nozzle
4. Cord wrap
g026691