Publicidad
Step 10
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (M) to the LEFT END (B) as shown in the
å
lower diagram. Use the screws in the HINGES. You should
start each SCREW a few turns before completely tightening
any of them.
Fasten a BACKPLATE (RR) and PULL (SS) to the DOOR (M).
å
Use a GOLD 1" MACHINE SCREW (III).
Peel the FELT DISC from the FELT DISC CARD (XX). Stick a
å
FELT DISC on the DOOR where it comes in contact with
the UPRIGHT (D2).
See the next step for DOOR adjustments.
å
XX
RR + SS
XX
www.sauder.com/services
B
M
GOLD 1" MACHINE SCREW
(1 used in this step)
D2
III
402375
Stop
Mounting
screw
Hinge
Page 15
Publicidad
