Operation - Kokido Telsa 80 Manual De Usuario

2. Make sure to assemble the handle. You need to hold it as well while putting the
pool vacuum into pool water or lifting it out of the pool.
Press the button of the V-clip to retract the side tabs and then slide the telescopic pole
onto the pole until the side holes of the telescopic pole match the side tabs. Release
the V-clip button and the telescope pole is secured to the pole connector.
To release the telescopic pole, press the V-clip button and pull the pole away from the
cleaner.

OPERATION

WARNING!
Do not use the pool vacuum if any damage is detected.
Oil stain could occur due to possible leakage of lubricants applied to the O-ring.
Do not operate this pool vacuum if there are people/pets present in the water.
Make sure the pool vacuum is fully immersed in the water before initiating operation.
The minimum water level required to operate the device must reach above the
power button of the pool vacuum when it is held in a vertical position. Operating the
pool vacuum when not immersed in the water correctly can damage the unit and
the warranty will be voided as a result.
Maximum operating depth in water is 3 meters (10 ft).
Maximum water temperature: 5˚C (41˚F) –35˚C (95˚F)
DO NOT use the pool vacuum without an intact filter screen in place. Using your
pool vacuum without an intact filter screen in place will VOID your warranty.
Suction entrapment hazard: This pool vacuum generates suction. Do not allow hair,
body or any loose parts of your clothing to make contact with the suction mouth of
the pool vacuum during its operation.
Never insert body parts, clothing or other objects into the openings and moving
parts.
DO NOT use this pool vacuum to pick up any toxic substance, flammable or
combustible liquids such as gasoline, or operate in the presence of explosive or
flammable fumes.
DO NOT cover the side slot of the vacuum during operation. The impeller/motor
may be damaged as a result.
Never insert any object to touch the impeller.
CAUTION
Use only original accessories delivered with this product.
DO NOT use this pool vacuum immediately after pool-shocking. It is recommended
to leave the pool circulating for at least 24-48 hours.
11