Getting Started; Charging The Battery - Kokido Telsa 80 Manual De Usuario

leave the pool vacuum plugged in for long-term storage. Recharge the
pool vacuum every three months.
Above warnings and cautions are not intended to incorporate all possible
instances for risks and / or severe injuries. Pool / spa owners should always
exercise extra caution and common sense when utilizing the product.

GETTING STARTED

IMPORTANT NOTE: Fully charge the pool vacuum before it is used for the first time.

Charging The Battery

WARNING!
Charging must be done indoors, in a well-ventilated area away from sunlight,
children, heat, ignition sources, and with an ambient temperature between 5˚C (41˚F)
and 35˚C (95˚F).
Never use the external adaptor and charging base if any damage is detected.
Use only the original external adaptor provided.
Make sure the pool vacuum and the charger base are clean and dry before set-up.
1. Turn the locking knob (on each side) anticlockwise until it points to the green dot
marking (unlock position) to unlock and release the rear body from the transparent lid.
2. Place the rear body (upside down - power on/off button face up) on a flat surface.
Open the protective cap on the rear body and align the 2 pins of the charger base
above the charging sockets. WARNING! Make sure not to invert the position of the
charger base. Press the charger base onto the rear body until it the pins are inserted
completely into the sockets. Plug the female jack of the external adaptor into the
charging port at the end of the charging base.
7