Setting Up The Product; Replacing The Rechargeable Battery - LIVARNO LUX HG04243A Instrucciones De Montaje

6. Insert the ground spike
downwards (see Fig. E).
7. Your product is ready for use.

Setting up the product

Insert the assembled product far enough into the ground (lawn,
flower bed) for it to be stable. Make sure you keep proper footing
and balance at all times. Do not use any force when assembling
or setting-up the product, e.g. hammer blows. This will damage the
product. In order to achieve the best result, set the product up in
a place where the solar cell will get direct sunlight for as long as
possible. Make sure that the solar cell is not influenced by any other
source of light such as yard or street lighting as otherwise the product
will not come on in twilight. The product automatically switches on
in twilight conditions and off again when normal outdoor lighting
conditions return.

Replacing the rechargeable battery

Note: Regularly clean the sensor and solar cell to ensure proper
functionality (refer to "Cleaning and care").
Replace the rechargeable battery as follows:
Set the ON / OFF switch
Loosen the fastening screws
type) and then open the battery compartment lid
solar cell housing
Remove the rechargeable battery
ment and replace it with a new rechargeable battery
10
ensure that you do not damage the wiring. Use only recharge-
able batteries of the recommended type (see "Technical data").
Please note the polarity when inserting the battery. This is indi-
cated in the battery compartment (see Fig. D).
into the base
12
to position "OFF".
1
by using a screwdriver (cross
7
(see Fig. B)
4
9
with the tip facing
11
8
from the battery compart-
GB/MT
from the
,
9
25