Cleaning And Maintenance - Concept RO 3207 Manual Del Usuario

Fig. 1
NOTE
When turning the unit on for the first time or after prolonged downtime, the unit may release a slight smell. This smell
will vanish after a short time.
OPERATING INSTRUCTIONS
1. Place the unit on a stable surface or floor to avoid tipping over.
2. Uncoil the supply cable.
3. Connect the power cord plug to the wall outlet.
4. Select the required function using the mode selector (Fig. 5)
3 Mode selector
0 – Off.
1 = low heat
2 = medium heat
3 = full heating capacity
5. You may set the required temperature in the room using the thermostat regulator. When heating function 1, 2, or 3 is
selected, the unit will alternately switch on and off, thus keeping the required temperature.
Note: More accurate temperature can be set as follows:
Set the thermostat to maximum, and switch the heating to 1, 2, or 3. When the required temperature is reached in the
room, turn the thermostat slowly to a lower temperature, until the unit switches off.
6. After use, move the mode selector to the 0 position and unplug the unit from the mains.

CLEANING AND MAINTENANCE

WARNING!
Before cleaning the unit, always disconnect the power cord from the wall outlet!
Prior to handling, make sure the unit has cooled down!
The surface of the unit may only be cleaned using a wet cloth. Do not use any detergents or hard objects, as they may
damage the unit's surface!
Dust accumulated in the unit may be blown out or removed by a vacuum cleaner.
Never clean the unit under running water, do not rinse it, and do not submerge it in water!
1 RO 3107, RO 3109, RO 3111
RO 3207 | RO 3209 | RO 3211
Fig. 2
RO 3207 RO 3209
0 W 0 W
600 W 800 W
900 W 1200 W
1500 W 2000 W
Fig. 3
RO 3211
0 W
1000 W
1300 W
2300 W
Fig. 5
EN
Fig. 4
27
33