Battery Charge - GYS MATIC 5/13 AIR XXL Manual De Instrucciones

INSTALLING THE BATTERY / CHARGING
1
Slide the battery towards the back of the filtration unit.
3
The battery is partially charged when delivered. It must be charged at a 100% (4 bars) before the first use.
It is recommended to charge the batteries at a 100% before each use.
The charger must not be used for anything else than it was desgined for. Do not charge the battery in a potentially explosive
area. The charger must only be used indoors.
The charger regulates the charge automatically, once the battery is fully charged, it will maintain it at a 100% (floating charge).
The charge time is 3 to 4 hours.
The battery will discharge itself after long storage periods. Always charge the battery if the device was stored for more than 15
days. Once the battery is new or has been stored for more than 3 months, charge it and discharge it at least twice in a row to
reach the nominal/rated charge capacity.

Battery charge :

1. Connect the charger to the mains.
2. Connect the battery to the charger. The connector is above the battery.
3. The state of charge is displayed via a red LED on the mains charger.
4. Once the charge is finished, the floating charge becomes active: the red LED switchs off and a green LED switches on.
5. Disconnect the charger from the mains (do not keep the charger plugged to the mains if it's not in use).
INSTALLING THE HOOD
1
Lower the helmet by pulling the handle.
To adjust the headband, refer to the GYSMATIC 5/13 XXL instruction manual.
12
GYSMATIC 5/13 AIR XXL
2
The battery can be charged on the filtration unit or separately.
2
Make sure that the battery is locked in position
Make sure that the hood is positionned properly, below the chin.
EN
.