Jeep 82209532 Guia De Inicio Rapido página 2

STEP 5
Re-install Hood Protector onto hood. Ensure that the boss
heads of the screwplugs locate into the slots in the Hood
Protector tags. Centralize and secure Hood Protector to
hood using the large screws and large washers provided.
See FIGURE 5.
STEP 6
Clean the areas under wing clip locations at either end of
Hood Protector, as shown. Clean these areas with alcohol
wipe provided. Wipe off any residue with a dry clean
cloth. Adhere abrasive resistant tape strips over hood lip.
Apply tape so approximately half of each strip is adhered
to topside and half adhered to underside of hood. See
FIGURE 6.
STEP 7
Position the nut insert into wing clips. Slide clips over
hood edge at the two outer noted positions.
IMPORTANT: Ensure the clips rest over the abrasive
resistant tape and do not come in contact with hood paint
work. Failure to do this may result in permanent paint
damage. See FIGURE 7.
STEP 8
Secure Hood Protector to clips with the small washers
and small screws provided.
TO REMOVE: Reverse above procedure.
IMPORTANT: Retain installation instructions for future
use. See FIGURE 8.
LARGE
WASHER
LARGE
SCREW
5
6
NUT INSERT
7
WING CLIP
NUT INSERT
WING CLIP
8
SUP271
2/6
82209532
K6859957
SMALL SCREW
SMALL WASHER
ABRASIVE RESISTANT
TAPE