Descargar Imprimir esta página

Jamara Germany Ultra BL 8 2,4 GHz Manual De Instrucciones página 3

Publicidad

ES - Reconocimiento de una batería llena.
Cuando conectes una batería llena al cargador, los LEDs se pondrán rojos durante unos segundos
y luego volverán a ponerse verdes. Esto signifi ca que la batería ya está completamente cargada.
Reconocimiento de una batería defectuosa.
Si los LEDs permanecen en verde cuando se conecta una batería vacía, hay un defecto en la
batería (defecto en la celda o descarga profunda). En este caso, desconecte la batería del cargador
inmediatamente y utilice otra batería.
¡Atención!
Después de cada carga es importante de: Desconectar siempre la batería
del cargador y el cargador de la fuente de alimentación. Si después de la
carga se deja conectado a uno o otra puede causar daños a la batería,
cargador o a la fuente de alimentación (peligro de incendio).
ES - Advertencia sobre las baterías:
Las baterías no recargables no se pueden cargar!
No abrir!
No arrojar al fuego!
No mezcle baterías nueva y viejas!
No mezcle baterías alcalinas, estándar (carbono-zinc) o baterías recargables!
Las baterías recargables deben retirarse del juguete!
Las baterías recargables sólo pueden cargarse bajo la supervisión de un adulto!
Los conectores de conexión no deben estar en cortocircuito!
1
Ahora ponga la batería en la porta baterías en el vehículo. Asegúrese de que el porta
baterías está asegurado correctamente con los 2 seguros para el porta baterías Incluidos.
Conecte ahora la batería con el regulador del modelo. Si el enchufe del regulador y el echufe
de la batería no coinciden, se incluye un cable adaptador con su modelo.
Encender la emisora y cerciórese de todos los botones del transmisor están en posición
neutral. Lea el capítulo para el uso del transmisor y sus controles cuidadosamente.
Mantenga el carro en el aire en caso de que el controlador (ESC) del motor se encienda a su
máxima potencia.
Encienda el control de la velocidad en el interruptor Encendido / Apagado (On / OFF).
Le sugerimos que active ahora la unidad receptora a Prueba de Fallas en el armado.
Cuando se suministra, está desactivado.
Si éste es su primer carro rc, le recomendamos conducirlo en una pequeña pista de prueba
para familiarizarse con el control del vehículo y los controles del transmisor.
Atención.
Apague siempre el modelo inmediatamente después de cada
uso. Inmediatamente después de cada uso, desconecte la
batería del modelo. La batería puede descargarse completa-
mente dejándola encendida o insertada accidentalmente. La
batería perderá energía o se dañará de tal manera que ya no
es posible cargarla o descargarla, o que podría incendiarse
durante el proceso de carga o descarga (peligro de incendio).
Nunca intente cargar o descargar baterías completamente
descargadas. El voltaje de la batería nunca debe ser inferior
a 6 voltios para evitar una descarga profunda. La batería completamente cargada tiene
una tensión de aproximadamente 8,4 voltios. Después de su uso, la batería intacta debe
cargarse completamente inmediatamente después de una fase de enfriamiento de un
mínimo de 10 minutos y un máximo de 12 horas para evitar una descarga profunda pos-
terior debido a la autodescarga. Si la batería no se utiliza o almacena durante un largo
período de tiempo, su tensión (mín. 8 voltios) debe comprobarse o si están dañadas al
menos cada 3 meses y, si es necesario, recargarse o desecharse.
GB - Detecting a full battery.
When you connect a full battery to the charger, the LEDs will turn red for a few seconds and then
turn green again. This means that the battery is already fully charged.
Detecting a defective battery.
If the LEDs remain green when an empty battery is connected, there is a defect in the battery (cell
defect or deep discharge). In this case, immediately disconnect the battery from the charger and
use another battery.
Instalación de las pilas en el transmisor
Inserte 4 baterías AA en la emisora.
GB - Battery warning:
Non-rechargeable batteries are not to be recharged!
Do not open!
Do not dispose of in fi re!
Do not mix old and new batteries!
Do not mix alkaline batteries, standard (carbon-zinc) or rechargeable batteries!
Rechargeable batteries are to be removed from the toy before being charged!
Rechargeable batteries are only to be charged under adult supervision!
The supply terminals are not to be short-circuited!
Regulador
ESC
Batería
Battery
Put the battery into the battery holder in the vehicle. Make sure that the battery holder is scured
properly with the 2 included clips for the battery holder.
Now connect the battery to the speed control in the model. If the plug of the speed control and
battery do not match, then you will fi nd a connection lead in your box
Turn the radio on and make sure all the trim buttons on the transmitter are in neutral position.
Read the chapter for usage of the transmitter.
Keep the car in the air in case that the motor turns at full power.
Switch the speed control on the On / Off switch.
We encourage you now to activate your receiver's built-in Failsafe unit.
On delivery it is turned off. (see chapter Fail Safe).
If this is your fi rst rc car, we recommend to drive it on a small test track to familiarise yourself
with the control of the vehicle and the controls of the transmitter.
Danger.
Always switch off the model immediately after each use. Immediately after each use the
battery should be disconnected from the model. The battery can be deeply discharged
by leaving it switched on accidentally or leaving it plugged in. Deep discharge causes
the battery to lose power or can be damaged to such an extent that charging or dischar-
ging is no longer possible or the battery can self-ignite during charging or discharging
(fi re hazard). Never attempt to charge or discharge deep-discharge batteries.
The voltage of the LiPo batteries should never be under 6 volt to avoid a depth dischar-
ge. The fully charged LiPo battery has a voltage of approx. 8,4 Volt.
After usage, the intact battery has to be fully charged after a cooling phase of at least
10 min but not longer than 12 hrs. This is to avoid a deep discharge caused by a self-
discharge. When not using or storing the battery´s it has to be checked at least every
three months for voltage (8 Volt) or damage and if necessary charged or disposed.
Danger!
Always disconnect the battery from the charger immediately after char-
ging. Always disconnect the charger from the power supply immediate-
ly after disconnecting the battery. Inserting the rechargeable battery or
charger after charging will result in damage to the battery, charger or the
power supply (fi re hazard).
Inserting batteries into the transmitter
Put 4 AA Batteries into the Transmitter
ON/OFF

Publicidad

loading

Este manual también es adecuado para:

059730 bl lipoGermany ultra bl 8 2,4 ghz059730