ProMed PBW- 5.2 Instrucciones De Empleo página 27

Medidor de la tensión arterial para el brazo
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 68
OPERATING THE UNIT
Putting on the arm cuff
1.
Place the arm cuff flat on a table with the hook and loop side facing
down. Pass the end of the arm cuff through the metal loop so that a
circle is formed. The hook and loop fastener is now visible from the
outside.
2.
Push the arm cuff over the left upper arm so that the tube lies in the
direction of the lower arm.
3.
Push the arm cuff over the arm as shown. Make sure that the lower
edge of the arm cuff lies about 2 to 3 cm above the elbow and the
rubber tube of the arm cuff lies on the inner side of the arm.
4.
Pull on the free end of the arm cuff and close the arm cuff using the
hook and loop fastener.
5.
The arm cuff should now be tight on your upper arm, so that 2 fin-
gers fit between the arm cuff and upper arm. Each item of clothing
that is tight on the arm must be removed.
6.
Fasten the arm cuff with the hook and loop fastener in such a way
that it fits comfortably and not too tightly. Lay your arm on a table
(palm upward), so that the arm cuff is at the same height as the heart.
Make sure that the tube is not kinked.
Please note:
If it is not possible to put the arm cuff on the left arm, it can also be placed
on the right side. All measurements should, however, be carried out on
the same arm.
Measurement
After the arm cuff has been suitably positioned you can start the measurement.
1. Measuring and saving the results
- To start measuring your blood pressure, use the START / STOP
button User 1
(A) or the START / STOP button User 2
depending on which user you are. First, the deflate symbol (13)
appears on the display since the device ensures that no residual air
is in the system. In addition, the most recent memory number as well
as the average measurement values of the user are displayed.
- When the device starts inflating the armlet, the following appears
on the display: the currently measured pressure (with increasing
values), the inflate symbol (14) and the blood pressure analysis
display (15).
27
(B),
DE
EN
FR
IT
ES
NL
RU
PL
SE
FI

Publicidad

Tabla de contenido
loading

Productos relacionados para ProMed PBW- 5.2

Tabla de contenido