Trust SuperSpeed 2 Manual Del Usuario página 3

SuperSpeed 2 Port USB 3.0 PCI Express Card – USER'S MANUAL
Fit card (Fit card)
Turn off your computer
Disconnect your computer's power cord
Open your computer's case
Locate a suitable PCIe slot on your motherboard
Fit the card into the PCIe slot
Connect the Floppy Drive Power connector to the card
Close your computer's case
Reconnect your computer's power cord
Turn on your computer
In case of "New Hardware Found" message, click "Cancel".
Install driver (Install driver)
Insert the Trust CD-ROM into your CD drive.
Click "Run Setup.exe – Published by Trust International BV"
Click "Install driver"
User Account Control warning: Click "Continue"
Welcome to the Installshield: Click Next
License Agreement: Tick "I accept the terms..." and click "Next"
Choose Destination Location: Click "Next" (To change the Destination Location, click "Browse",
change the location and click "Next")
Ready to Install: Click "Install"
Installshield Wizard Complete: Click "Finish"
A popup message indicates the driver was correctly installed. You can now connect USB devices to the
Trust SuperSpeed 2 Port USB 3.0 PCI Express Card.
For full USB 3.0 performance, all devices and cables must be USB 3.0 compliant.
The Trust SuperSpeed 2 Port USB 3.0 PCI Express Card is backwards compatible, and will also allow you to use
your USB 1.1 and USB 2.0 devices.
2