Inateck P7 Guia Del Usuario página 4

Use of Inateck P7
EN
Startup
Note:
1) Inateck P7 will start sleep mode if there is no operation on it over 3 minutes. Short press
on the trigger can wake it up.
2) When the distance between Inateck P7 and its adapter exceeds the effective range,
scanned data will be kept in the buffer of Inateck P7. Quickly double press on the trigger
can upload data from buffer.
Connection Modes
There are 3 kinds of modes for the P7 barcode scanners to connect with another device.
They are Wired Mode, Wireless Adapter Mode, and Bluetooth Mode. As long as you
connect the P7 barcode scanner to a device via the USB cable, the scanning data will be
transmitted via the cable, while Wireless Adapter Mode and Bluetooth Mode will not work.
Wireless Adapter Mode（Plug and Play）
Wireless Adapter Mode is the default connection mode. To use this mode please refer
to the details below.
1. Power on Inateck P7 by toggling switch from OFF to ON
2. Plug the USB adapter into a computer. If the indicator light flashes once, it means the
connection is successfully built. Short press the trigger on the barcode scanner and
it will emit red light beam, and then the barcode scanner can work under Wireless
Adapter Mode.
3. Open a file on the computer and move cursor to the place where scanning result should
be displayed and saved.
Note：
1) Wireless Adapter Mode is the default connection mode of P7 barcode scanner. If you are
using Bluetooth connection mode and want to switch it back to the Wireless Adapter
Mode, please scan the setting barcodes in sequence "Enter Setup" - "Wireless Adapter
Mode" - "Exit with Save".
2