Royal Catering RCEF 10EH Manual Del Usuario página 9

and to switch the device on by setting the switch to
the „On" position). Once the required temperature
has been reached, the heating light will go off. The
thermostat will maintain the required temperature
by automatically switching the heating element on
and off. This maintains the required temperature and
saves electricity. You may begin frying.
4. Use the baskets after mounting the handles. Place
food in the basket and immerse it into the oil. When
the food is tried, hang the basket up on the nail to
let the oil drop off.
ATTACHING THE HANDLE TO THE BASKET
5. The covers are designed to keep the content warm
and t protect it from dirt. If you want to use the
covers, make sure they are not wet.
6. When you have finished working, tilt the heating
elements 90 degrees backwards. The heating
elements are vertical, and the oil can drop off.
7. Our fryers are equipped with a safety buton.
When the heating element is tilted back, it turns
automatically to prevent from accidents.
8. Once the oil cools down to room temperature,
discharge it using the release valve (applicable for
models: RCEF 10EH, RCEF 13EH, RCEF 16DH, RCSF
16ETH, RCSF 16DTH, RCKF 16ESH, RCKF 16DSH) or to
pull out the bowl for oil and to empty it (applicable
to models: RCTF 13EH, RCTF 13DH, RCEF 10EY-ECO,
RCEF 10DY-ECO).
9. Make sure the thermostat is back to „0" (adjust
the thermostat knob anticlockwise). Set the On /
Off switch to the „Off" position and disconnect the
device from the power supply.
10. It is recommended to use only liquid oil or fat in the
fryer to avoid damages of the temperature limiter.
It is not recommended to put block fat in the fryer
– block fat should be melted before putting it into
the fryer
ATTENTION! The device has a sensor to prevent it
from overheating. If the device overheats when
in use it will automatically switch off. Then it is
necessary to wait until the device cools down and to
reset the protection by pressing „RESET". The device
may be used again.
4. CLEANING AND MAINTENACE
• Always unplug the device before cleaning it and
after each use.
Rev. 17.10.2018
• Discharge oil and remove heating element.
• Use a damp cloth suitable for cleaning devices or use
natural vinegar suitable for food grade equipment.
• Do not use water to wash the electric control panel
as this might cause damage and invalidate the
warranty.
• Use cleaner without corrosive substances to clean
surface.
• After cleaning the device, all parts should be dried
before reusing it.
• Store the unit in a dry, cool place, free from moisture
and direct exposure to sunlight.
9