Sanus VST15 Instrucciones De Montaje página 6

2 Mount the Wall Plate
Wood stud
2-1
Locate stud
2-2
Mark the wall
[02]
2-3
Drill pilot holes
2-4
Tighten lag bolts
[02]
[03]
6
Verify the center of the stud using an awl, a thin nail, or an edge to
edge stud fi nder.
< 16 mm
(5/8 in.)
damage!
Level the wall plate [02] and mark the hole locations.
holes MUST be drilled to a depth of 63½ mm (2½ in.), using a 3 mm
(1⁄8 in.) diameter drill bit.
Improper use could reduce the holding power of the lag bolt. To avoid
potential injuries or property damage
CAUTION:
Avoid potential personal injuries and property
Any material covering the wall must not exceed 16 mm (5/8 in.).
Minimum wood stud size: common 51 x 102 mm (2 x 4 in.)
(nominal 38 x 89 mm (1½ x 3½ in.)).
CAUTION:
Avoid potential injuries or property damage! Pilot
63½ mm
(2½ in.)
CAUTION:
Avoid potential injuries or property damage!
DO NOT over-tighten the lag bolts [03].
Tighten the lag bolts [03] only until they are pulled fi rmly against
the wall plate [02].
12 mm 3 mm
(7/16 in.) (1/8 in.)
6901-002130 <00>