Publicidad
Idiomas disponibles
Idiomas disponibles
• Connect your audio sources to the analogue connections.
• Connect the supplied mains cable to the rear and then insert the other end into a 230V socket.
• Turn the volume knob to the left to a low volume setting.
• Actuate the on/off switch on the rear side, the device is now in the standby mode.
• Switch on the MA 800 using the ON/STANDBY button on the front panel or the remote control.
• When the tubes have heated up the device is ready for use.
• Select your desired audio source using the input selector switch.
PROTECTIVE CIRCUIT
To ensure maximum protection for the amplifier and the connected speakers the MA 800 is equipped
with a protective circuit. In the event of a short circuit, overcurrent or DC offset it separates the speaker
outputs from the amplifier. In this case "PROTECT" is indicated in the display. The device must be
disconnected from the power supply and the cause of the malfunction determined. Start by checking
the wiring of the speakers. If the malfunction occurs again, please contact a specialist and get the
amplifier and/or the speakers checked.
TUBE REPLACEMENT
The device has a high quality preamplifier stage which is equipped with two tubes. The tubes have a
very long service life when used under normal operating conditions (min. 20,000-50,000 hours).
If it is necessary to replace the tubes, please refer to a specialist dealer.
SERVICE AND TECHNICAL PROBLEMS
If you should encounter any technical problems, please contact your specialist dealer or Magnat
Audio-Produkte GmbH, Tel.: 02234807-0.
GB
SPECIFICATIONS
Amplifier
Power output:
Rated power
Peak power:
Frequency response :
Phono
Signal to noise ratio:
CD/Tuner/Aux/Line/Tape
Phono MM
Phono MC
Input sensitivity/impedance:
CD/Tuner/Aux/Line/Tape
Phono MM
Phono MC
Fitted with:
Phono Preamplifier:
Miscellaneous
Mains voltage:
Electricity consumption:
Dimensions (wxhxd):
Main device:
Main device incl. operational
elements/connecting terminals: 430 x 125 x 380 mm
Remote Control:
Weight:
Subject to technical change.
For further information please visit our website: http://www.magnat.de.
10
20 Hz – 20 kHz, THD < 1.0%, 4 ohm
2 x 110 W
20 Hz – 20 kHz, THD < 1.0%, 8 ohm
2 x 75 W
1 kHz, 4 ohm
2 x 200 W
5 Hz – 100 kHz (-3 dB)
20 Hz – 20 kHz (+/- 0,1 dB)
20 Hz – 20 kHz (+/- 0,3 dB)
Subsonic filter: 16 Hz, 18 dB/octave
110 dB
88 dB
75 dB
400 mV / 100 kohm
2 mV / 47 kohm
0,3 mV / 470 ohm
2 x ECC 82
230 VAC / 50 Hz
Max. 250 W
Standby 1,0 W
430 x 125 x 330 mm
45 x 190 x 23 mm
11 kg
Publicidad
