Cleaning And Maintenance - Beurer BARBERS CORNER HR 4000 Instrucciones De Uso

4. Press the ON/OFF button
5. Position the edge of the comb attachment for
the slim contour blade against the desired area and move the device
downwards as shown in the adjacent image.
6. When you are finished, press the ON/OFF button
device.

9. Cleaning and maintenance

Clean the device
WARNING
• Always pull the mains adapter out of the socket before cleaning the device. Risk of electric shock!
Before cleaning, always ensure that the device is switched off.
• Remove the comb attachments before cleaning.
• Only clean the housing of the device with a soft cloth dampened with warm water or the cleaning
brush supplied.
• Do not clean the device with highly flammable liquids. Risk of fire!
• Do not clean the device in the dishwasher.
• Clean the comb attachments as well as the shaver unit and the slim contour blade after each use to
prevent lots of hair getting jammed inside, which could otherwise impede flawless operation.
• Do not use any aggressive, caustic, abrasive or corrosive cleaning products or hard brushes.
Cleaning comb attachments
Blow on the comb attachments after the application in order to clean them of
hair. You can also carefully remove wet hair with your fingers.
To clean the comb attachments particularly thoroughly, you can rinse them
under running water.
Proceed as follows:
1. Pull the relevant comb attachment off the device.
2. Hold the comb attachment under running water.
3. Leave the comb attachment to dry completely before you reattach it to
the device.
Cleaning the trimmer attachment and slim contour blade attachment
Blow on the trimmer attachment and the slim contour blade attachment af-
ter use in order to clean them of hair. You can also remove wet hair with your
fingers.
WARNING
When cleaning with your fingers, make sure that you do not injure yourself on
the sharp edges of the stainless steel blade.
To clean the stainless steel blade or the slim contour blade particularly thoroughly, you can also rinse
them under running water. Proceed as follows:
1. Pull the stainless steel blade or the slim contour blade up and off the device.
2. Hold the stainless steel blade or the slim contour blade under running water, so that the stream of
water runs through the stainless steel blade or the slim contour blade from the inside out.
to switch on the device.
24
to switch off the