Maintenance And Care; Tips And Tricks; Statement Of Conformity - Parkside PEH 900 Instrucciones Para El Manejo Y La Seguridad

CHANGE TOOTHED BELT
Unscrew the screws in the cover and take off the toothed belt cover . Cut through the toothed belt with side-cutting pliers or a knife and
remove the severed toothed belt. Always clean off any dirt or debris from the pulley and the drive wheel before installing the new belt.
Place the new toothed belt on to the drive wheel and push the belt over the large pulley wheel whilst turning it.
Put the toothed belt cover back in place and fasten with the screws.

MAINTENANCE AND CARE

Clean the planer regularly. For the best results do this straight after the work has been completed. Do not allow liquids to get inside the planer.
Use a soft cloth for cleaning the housing. Do not use petrol, solvents or cleaners that might attack the plastic. Air vents must always be
clear and clean.

TIPS AND TRICKS

01. Do not use too much forward pressure. - Too much pressure can considerably reduce performance and increase the wear on the blades.
02. Always use sharp blades and replace blunt blades promptly. - You will get better cutting performance and extended tool life.
03. To obtain smooth planed surfaces we recommend that you use shallow planing depths and plane the surface a number of times.
Further practical tips for power tools can be found in the accompanying booklet on safety advice.
We reserve the right to make technical modifications in the course of further development.

STATEMENT OF CONFORMITY

We, Kompernaß Handelsgesellschaft mbH, Burgstr. 21, D-44867 Bochum, Germany, hereby declare
that this product conforms with the following EC regulations:
EC machine guideline:
EC low voltage regulations:
Electromagnetic compatibility:
Applicable harmonised standards:
Manufacturer:
Model type:
Description:
Bochum, 01.04.2002
Hans Kompernaß
- Managing Director -
(89/392 EEG), (91/368 EEG), (93/44 EEG), (93/68 EEG)
(73/23/EEG), (93/68 EEG)
(89/336 EEG), (92/31 EEG), (93/68 EEG)
EN 50144-1:1998, EN 50144-2-14:1996, EN 55014-1:1993+A1
EN 61000-3-2:1995+A1+A2, EN 61000-3-3:1995, EN 55014-2:1997
PARKSIDE
PEH 900
POWER PLANER
11