RODCRAFT MBX - RC7091 Manual De Instrucciones página 15

MBX System Pneumatic
Active
Rotation
Correct Incorrect
Corner
Phase 1
Warning: Always be sure that the tool is disconnected before attempting to perform inspection or maintenance.
Phase 1:
The belt works at full efficiency: Even a slight amount of pressure on the belt will remove a lot of material. The bristle tips
are sharp and straight. They don't break off.
Phase 2:
The sharp bristle tips have become dull. The operator increased pressure on the belt to try to compensate for the deceased
efficiency of the slowly dulling tips. This caused the bristles to be bent backwards and some of the bristle tips fell out. The
belt is worn out and must be changed.
Phase 3:
If you do not change the belt in Phase 2, the condition of the belt will be as shown in Phase 3.
Explanation:
A traditional sanding disc is used up in a constant curve (see diagram) and you can see how much it has been used and
how much life remains. Conversely, in Phase 1, the belt operates with no visible wear for a long time. The rapid progres-
sion to Phase 2 and then to Phase 3 is considered normal.
Our Tip:
If the belt begins to lose efficiency, check the belt bristles for wear. If wear has progressed to Phase 2, change the belt.
Increasing the pressure is incorrect use and will reduce the life of the belt. You can extend the life of the belt in Phase 1 by
re-sharpening the bristles.
Do not bear down excessively
extended lifespan
Ok
Special Uses
Curves
Phase 2 Phase 3
Operating Instructions GB
Observe correct
working position
No Ok
Ok
Edges
Ok
Performance
100 %
Phase 1
50 %
Grey line:
belt of MBX 3500
Black line: traditional sanding disc
0 %
No
No
No
Phase 2
Phase 3
100 %
Durability
15