Trouble Shooting - Parkside PRM 1300 A1 Traducción Del Manual De Instrucciones Original

Trouble Shooting

Problem
Equipment
does not start
Motor stops
Result
unsatisfactory
or motor
labours
Blade fails to
turn
Strange noises,
rattling or
vibrations
Possible Cause
Power is off
Defective on/off switch (
Worn carbon brushes
Defective motor
Grass too long
Blockage by foreign object
Cut height too low
Blade ( 18) blunt
I
Blade area blocked
Blade assembled incorrectly
Blade blocked by grass
Blade screw ( 17)loose
I
Blade screw ( I 17) loose
Blade damaged
Fault Fixing
Check the socket, cable, wire and
plug and have any repairs carried
out by an electrician
A
12)
Repair by customer services
Set a greater cut height. Lift the front
wheels slightly by pressing down on
the handle bar (
Remove the foreign bject
Set a higher cut height
Have the blade sharpened or
replace it
Clean the equipment
Install the blade correctly
Remove the grass
Tighten the blade screw
Tighten the blade screw
Replace the blade
GB IE
A 1).
33