Output The Arb Waveform - Beta 1760DGT/2 Manual De Usuario

Output the arb waveform

1. Install the software
Download the latest software on the official website, double click Setup.exe to install.
2. Install the driver
Connect the oscilloscope to the computer through the USB cable. Open the device
manager of the computer and find the device. If the device icon is shown in the
following picture, you need to install the driver manually.
Download the driver on the official website. Right click the driver, and select "Update
the driver software", and select the driver files path to install.
After successful installation of the driver, it is shown as follows:
3. Double-click the icon to open the software and select "DDS" in the right control bar to
enter the signal generator control bar.
4. Put "√" in the box in front of "on/off" to open the signal output.
5. Select "signal type" as "arb", and set the corresponding frequency and amplitude;
6. Select "Arb Channel" as Arb1/Arb2/Arb3/Arb4. Each arb channel can save only one
arbitrary waveform which was downloaded last time. Turn on again after shutdown,
and automatically recall.
7. Draw arbitrary waves in waveform area with mouse.
74