3 Change the login password by entering a new
password and clicking Apply.
If you changed the password and have forgotten it, you need to return the ZyWALL to the
defaults (password is 1234, LAN IP address is 192.168.1.1, etc.). Press the RESET button
(on the rear panel) until the PWR LED starts to blink, then release it.
5 The HOME screen opens.
The ZyWALL is in router mode by default. Continue to the next step if you want to use routing features
such as NAT, DHCP and VPN.
Go to section
3
if you prefer to use the ZyWALL as a transparent firewall.
6 Check the network status table. If the WAN 1 status is not Down and there is an IP address, go to section
5.
If the WAN 1 status is Down (or there is not an IP address), click the Wizard icon and use section
configure WAN 1.
ENGLISH
4 Click Apply to replace the ZyWALL's default
digital certificate.
4
4
to