Rev-A-Shelf 5149-15DM18-111 Manual De Instrucciones

Single 35 & 50 qt.
Double 27 qt.
TOOLS REQUIRED:
3
32
1) Pre-drill mounting holes in the locations marked on this template using a 3/32" drill bit. Be sure the template is centered left to right. The front edge of the template should be aligned with the back of the door.
2) Use the #8 x 3/4" Phillips head screws provided to secure the unit to the floor. The slide system can be separated if necessary to aid in installation, but removal is not required (See Fig 1 and Fig 2).
3) Ensure that the door mounting brackets allow the mounting screws to engage a part of the door that is at least 3/4" thick (On a 5-panel door, this would be the outer side pieces, or styles). Inset doors would move the
brackets toward the center of the unit while full overlay doors would require the brackets to move outward (See Fig 3). Use the double sided tape provided to temporarily attach the door to the mounting brackets.
4) Carefully open the unit, being sure not to disengage the double sided tape. Once the unit is open, use the #6 x 1/2" flat head screws to permanently attach the door to the unit. All (8) screws must be used for proper
function. Space screws at opposing corners as much as possible.
Door Adjustment
Vertical mounting slots in the bracket that attach directly to the door can be used for vertical adjustment (See Fig 4).
Horizontal adjustment is achieved by loosening all (4) of the 3/8" nuts that connect to the (2) brackets and moving the door left to right as needed (See Fig 4).
For door tilt adjustment, loosen the (4) #3 Phillips head screws below the skirt and adjust as needed. The rear screws are slotted to allow the door to pivot at the front of the bracket (See Fig 5). Keeping the front screws
"snug" will aid in adjustment.
Place a flat head screw driver between the metal clip and plastic
hub. Gently pry to relieve pressure by popping the clip out,
taking care to keep it intact.
Fig 1
Door thickness must be at least 3/4" where screws attach.
For horizontal adjustment loosen 4 3/8"
nuts and move to desired position.
Fig 4
Front edge of paper
to back of door.
5149 Series Waste Container Installation Template
ESTIMATED ASSEMBLY
TIME:
20 MIN
Plastic hub
Mounting screws must engage 3/4" thick
material minimum.
Adjust bracket left to right before
attaching door with double-sided tape.
Use vertical slots for
vertical door adjustment
Front of unit
CARE AND MAINTENANCE:
CLEAN WITH A DAMP CLOTH
AND WIPE PARTS DRY
(5) Recommended Screw and Pilot
Fig 2
Press release lever behind side skirt on each side by sliding up
or down depending on which side. Unit will separate when both
levers are disengaged.
Fig 3
Fig 5
Door tilt adjustment screws
Center of cabinet
PARTS LIST:
PULLOUT CHASSIS
WASTE CONTAINER CHASSIS
WASTE CONTAINER(S)
(8) #6 X 1/2" FLAT HEAD SCREWS
(5) #8 X 3/4" PAN HEAD SCREWS
DOUBLE SIDED TAPE
Hole Locations
12400 Earl Jones Way
Louisville, KY 40299
rev-a-shelf.com
Customer Service: 800-626-1126
T-5149-0119