Rev-A-Shelf 5322 Serie Instrucciones De Instalación

TOOLS REQUIRED:
ESTIMATED ASSEMBLY TIME:
30 MIN
CARE AND MAINTENANCE:
Clean with a damp cloth and
wipe parts dry.
PARTS LIST
A- Frame assembly
B- Slide assembly
C- Release levers
D- Rear slide catches
E- (4) Euro screws
F- (4) #6x 5/8" Flat head screws
G- (4) #8x 3/4" Pan head screws
H- (4) #6 x 1/2" Flat head screws
(for door mounting)
FIG. 1
FIG. 1A
FIG. 2
FRONT EDGE OF PAPER TO FRONT
OF EDGE OF CABINET OPENING OR
FRONT OF FACE FRAME.
IF INSTALLING IN INSET DOOR
APPLICATION, MOVE TEMPLATE
BACK THE THICKNESS OF THE
DOOR.
6-1/2" 5322 BASE ORGANIZER
(4) Screw and Pilot
Hole Locations
A B
1) Using the mounting template locations, pre-drill (4) holes using a
3/32" drill bit.
2) Secure the slide assembly to the floor of the cabinet using (4)
#8x3/4" pan head deep thread screws.
3) Assemble release levers using (4) #6x5/8" flat head screws and rear
slide catch using (4) Euro screws (Fig. 1).
4) With the slides in the fully closed position, the pullout chassis can
now be fully inserted into the cabinet. When the unit is pushed to
the fully closed position, the front release levers will engage the
slides and the unit can be fully cycled.
5) Loosen the (2) lock nuts at the back of the unit to allow the rear stop to
float freely (Fig. 2). Move the rear stop until it catches the rear of the
face frame (if frameless application, a block may need to be added
to allow the stop work properly). Once the rear stop is in the correct
position, the lock nuts can be tightened and bumpers can be added
to the front of the stops.
ATTACHING THE CABINET DOOR
1) With an 8 mm wrench, loosen the (4) lock nuts located inside the front
wall of the unit (Fig. 3).
2) Adjust the door mount brackets to ensure you are mounting to the
thick portion of the cabinet door (the front of the unit should be
lined up with the front of the face frame).
3) Using (4) #6x1/2" flat head screws, attach the door to the pullout
unit.
4) If the door needs to be adjusted sideways, loosen the (4) lock nuts and
adjust the door (Fig. 4).
5) See (Fig. 5 and 5A) for tilt and height adjustment.
Install rub bushings using enclosed kit and instructions.
(Chassis may need to be removed for proper installation)
Front Edge of Paper
to Front of Cabinet
(or Front of Face Frame)
C E
F
D
G
H
12400 Earl Jones Way
Louisville, KY 40299
rev-a-shelf.com
Customer Service: 800-626-1126
FIG. 3
Lock Nut
FIG. 4
FIG. 5
FIG. 5A
FOLD ALONG DOTTED LINES TO FIT
INTO CABINET
T-5322-65-1217