– If an extension cord is necessary, a cord with a proper
rating should be used. A cord rated for less amperes
or watts than the appliance rating may overheat. Care
should be taken to arrange the cord so that it will not
be tripped over or pulled.
– Check that the voltage shown on the label of the unit
corresponds to the voltage of the mains supply.
– Disconnect all electrical appliances from the mains
before placing hands in the water.
– The line cord of this unit cannot be replaced or repai-
red. Should the line cord become damaged the appli-
ance must be discarded.
KEEP THESE INSTRUCTIONS FOR
FUTURE REFERENCE.
English
Only for use in rooms. For aquaristic applications.
Before placing your hand in the aquarium
water, ensure that all electrical appliances in
the water have been switched off at the mains.
The mains cable g of the device cannot be re-
placed. If the cable of the heater and glass
tube is damaged the device should not be used
any longer. In case the heater is defective or
does not heat properly, do not try to open or
repair it. In this case please contact our custo-
mer service.
Attention: Electric Shock Hazard
For your own safety we recommend that you
allow the mains cable to form a drip loop h
which ensures that water running along the
cable cannot drip into the mains socket. If a
multiple socket is used this must be placed
above the mains connection of the thermosta-
tic aquarium heater.
This equipment can be used by children above
the age of 8 or by persons with reduced physi-
cal, mental or sensory capacities or a lack of
experience or knowledge, provided they are
supervised or have received instruction in the
safe use of the equipment and therefore
understand the risks involved. Do not allow
children to play with this equipment. Do not
allow children to clean or conduct user main-
tenance without supervision.
Risk of burning: • Never switch on the
heater outside the aquarium • Do not
handle or touch the heater inside the
heating area • Switch off the heater
Safety instructions