Description; Operation; Security - Vortice Thermologika Soleil Plus Manual De Instrucciones

ENGLISH

Description

The appliance Thermologika Soleil Plus (indicated as
TSP in the following) is a waterproof infrared lamp
(protection level IPX5) for use as supplementary
heaters, to be wall or ceiling mounted. The TSP uses
the principle of irradiation (like the sun itself), to
transmit heat to objects by means of the light rays
emitted from the lamps.
Since it has no moving parts, the TSP is totally silent
in operation.
The appliance must only be connected to a power
supply with an impedance of no more than
|Z|=0,333Ω.

Operation

TSP is particularly suitable for use in domestic,
commercial or industrial environments, especially
when more or less instant heat is required in restricted
areas. A potentiometer (optional) is used to adjust the
amount of power delivered.
ATTENTION: TS must be connected to a fixed
power supply network.

Security

Warning:
!
this symbol indicates that care must
be taken to avoid injury to the user
• This appliance is manufactured to a high standard of
craftsmanship: to ensure a long service life and
overall electrical and mechanical reliability it must be
used in a proper manner and subjected to regular
maintenance.
• Do not use this appliance for functions other than
those described in this booklet.
• After removing the appliance from its packaging,
ensure that it is complete and undamaged. If in
doubt contact Vortice.
• Do not leave packaging within the reach of children
or differently able persons.
• Do not sit on the appliance or rest objects on it.
• Certain fundamental rules must be observed when
using any electrical appliance:
- Never touch appliances with wet or damp hands
- Never touch appliances while barefoot
- If using this appliance where there are children,
supervision by an adult is necessary; this appliance
must not be used, without assistance, by children or
persons whose physical, sensory or mental
capacities prevent them from applying the
necessary safety precautions.
• Do not use the appliance where flammable vapours
are present (spirit, insecticides, petrol, etc.).
• If you decide to stop using the appliance, switch it
off and disconnect it from the power supply, storing
it out of reach of children and differently able
persons. Also cut off the power cable to render the
appliance unusable.
• Do not use the appliance in the immediate vicinity of
bath tubs, showers or swimming pools. Always
respect the safety distances prescribed by EEC-CEI
standards.
• The appliance becomes very hot during use. Avoid
all contact between your skin and the hot surfaces of
the appliance. Switch the appliance off and wait at
least 5 minutes for it to cool down before performing
any work on it
Caution:
!
this symbol indicates that care must
be taken to avoid damaging the appliance
• Do not make modifications of any kind to this
appliance.
• Pay special attention when using it in rooms that are
not manned.
• Regularly inspect the appliance for visible defects. If
any faults are found, do not operate the appliance
but contact Vortice* immediately.
• Never position the appliance directly under a power
socket.
• The appliance must always be mounted horizontally
• The appliance must be properly connected to an
electrical system in compliance with the applicable
regulations and equipped with an efficient earthing
system. If in doubt, have a qualified electrician
perform a thorough check.
• The appliance must be installed by a professional
technician, according to the instructions given in this
booklet. Vortice cannot assume any responsibility
for damage to property or personal injury resulting
from failure to abide by the instructions given in this
booklet.
• Use a multi-polar switch with minimum contact gaps
of 3 mm when installing the appliance.
• Connect the appliance to the electrical power supply
only if the system is able to provide the maximum
electrical voltage and capacity indicated on the
rating plate at maximum power.
• Before carrying out any type of cleaning or
maintenance operation, turn the appliance off and
turn the main power switch off to disconnect it from
the power supply.
• Should the appliance be dropped or suffer a heavy
blow, have it checked immediately by Vortice.
• When carrying out maintenance operations, never
touch the bulbs directly, but only the terminal
casings. The bulb will be damaged by contact with
naked hands; in this eventuality the product
guarantee will no longer be considered valid.
• In the event of accidental contact with the surface of
the bulb, clean it immediately by wiping with a cloth
dipped in alcohol.
• If the appliance does not function correctly or
develops a fault, turn it off and contact Vortice*
immediately.
• Ensure that only genuine original Vortice spares are
used for any repairs. If the cable or the power plug
are damaged, take the appliance to an authorised
Vortice service centre for replacement.
• Switch off the appliance at the main switch: a) if the
appliance does not function correctly; b) before
7