Adjustment For The Width Of Edge Banding Material; Adjustment For The Amount Of Glue - HOLZMANN MASCHINEN KAM 45PRO Instrucciones De Servicio

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

13.3.3 Adjustment for the width of edge banding material

13.3.4 Adjustment for the amount of glue

NOTE:
Do not set adjustment knob after machine has cooled down. Part of the
adjusting components will get stuck by the glue, hence no turning on the knob is
allowed.
HOLZMANN MASCHINEN GmbH
 Loose screw and insert a sample edge into the side of the
hold-down clamp.
 Move down the clamp to tough the edge band and set the
width of the band.
 Tighten the screw.
 Adjusting glue amount: the adjusting knob (1) can
control the amount of glue applied onto the edge
banding material (only when the machine is heated
up and the glue granulate is liquid!).
 When machine has heated up and the glue granulate
has become liquid, feed a sample edge to check the
amount of glue applied on it.
Adjust until the edge is coated evenly.
www.holzmann-maschinen.at
OPERATION
28
KAM45PRO

Publicidad

Tabla de contenido
loading

Tabla de contenido