Install The Chute Control Rod; Install The Battery Pack; Remove The Battery Pack; Operation - GreenWorks SNF402 Manual Del Operario

1. Push the chute deflector.
2. Make sure that the tabs engage the slots on the two sides.
3. Make sure that the posts engage the holes on the two
sides.
3.5 INSTALL THE CHUTE CONTROL
ROD
Figure 4-5
1. Align the holes in the upper chute control rod and lower
chute control rod.
2. Put the hitch pin through the holes.
3. Align the arrows in the discharge chute and snow thrower
deck. Make sure the discharge chute faces forward.
4. Put the end of the chute control rod straight through the
hole in the bracket. Keep the grip handle down.
5. Push the chute control rod into the hole behind the deck.
6. Turn the grip handle left and right to make sure that the
discharge chute moves in the same direction.
3.6

INSTALL THE BATTERY PACK

Figure 6
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Open the battery door.
2. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.
3.7

REMOVE THE BATTERY PACK

Figure 6
1. Open the battery door.
2. Push and hold the battery release button.
3. Remove the battery pack from the machine.
4

OPERATION

WARNING
Wear eye protection during operation.
English
4.1

COLD WEATHER OPERATION

The safe battery operation temperature ranges from 1°F
(-17°C) to 113°F (45°C).
Do not store or charge battery outside.
Battery must be charged and stored indoors prior to use of the
machine.
If the machine does not start below 1°F (-17°C),
• remove the battery pack from the machine,
• charge the battery pack for 10 minutes in warm area, or
when the charging light turns green.
• Install the battery pack again.
4.2

START THE MACHINE

Figure 7
1. Put in the safety key.
2. Pull the bail switch to start the machine.
Lower the scraper to the ground to remove the snow.
Keep bystanders a safe distance from the machine.
Examine the work area. Remove all stones, sticks, wire,
bones, and other debris that can ricochet because of the
rotating impeller.
4.3

STOP THE MACHINE

Figure 7
1. Release the bail switch to stop the machine.
Wait until the impeller fully stops before you start the
machine again. Do not quickly turn the machine off and on.
Remove the battery pack after you complete the work.
4.4

ADJUST THE DISCHARGE CHUTE

Figure 8
You can adjust the discharge chute 180° to change the snow
direction.
1. Turn the grip handle left to move the discharge chute to
the left.
5
WARNING
NOTE
WARNING
WARNING
WARNING
WARNING
EN