imilab KW66 Manual Del Usuario página 4

2. After installing the APP, open and log in GloryFit, then select
(device KW66 to be added) on the device page so as to connect
it.
Tips:
In the process of pairing, check if the Bluetooth functionon
your mobile phone is enabled, so that the watch can be
connected to your mobile phone.
If the device cannot be found in the pairing process, or the
device cannot be connected during use, please click
"Settings - Reset" on the watch, then try to start the pairing again.
If the watch still can not be found, please exit and re-open the
APP.
The connection status of the watch is as shown in the figures
below :
Not connected
Note: The battery power will be shown as 5 different levels on
the watch (0%-25%-50%-75%-100%)
Operation
1. Open the control panel: Swipe the screen on the main interface
downwards from the top
2. Open the messages/notifications: Swipe the screen on the
main interface upwards from the bottom
3. Open the main menu:Swipe the screen on the main interface
from left to right (Note: On other interfaces, slide your finger
from left to right to return to the previous interface)
4. Open the status interface: Swipe the screen on the main
interface from right to left
5. Quick dial change: Press and hold the dial interface for 3
seconds, and the watch vibrates once; then you can slide your
finger to left or right to select the dial.
6. Power on: Press and hold the Power button for 5 seconds to
switch it on (Power off: You need to press and hold the button
for 3 seconds when the display is on to select whether to power
off)
7. Quick sports pause/continue: Press the power button.
8. Press the power button to return to the homepage (Note: If
you are on the level 2 interface, you will return to the level 1
interface).
Connected
EN-02