3.4
Stage 4 – cont'd
4.
Fix the Worktop in place using
a) The large workshop fixing and large
screws as shown.
b)
the small screws to fix the worktop
fixing plates.
Plan View
5.
Position the Javelin cutter onto the two
lift & hold mechanisms by sliding the
tongue into the slot inside the end caps
of the Javelin.
NOTE:
The friction knob on each mechanisms can
be adjusted to hold the Javelin at any height
which makes accurate lining up easier when
in use.
6.
Move the cutting head to one end of
the Javelin and depress the blade,
adjust the position of the lift & hold
mechanism so the blade runs centrally
in the slot on the base extrusion,
tighten the three screws to fasten the
lift & hold.
Repeat for the other end.
7.
Position the bench in place and using an accurate spirit level adjust the feet to ensure the top
surface of the table is flat. If the table is not flat, particularly along it's length, there may be difficulty
in holding the workpiece in place along the full cut length.
Assembly
a
Position brackets approximately
as shown
b
Move lift & hold to align
blade in slot
3.4