KEENCUT Big Bench Instrucciones De Montaje página 9

3.5
8. If a thin film or paper is being cut check that the material can be gripped along the full length of the
bench. Pass a small piece of the material about 25cm (10") wide under the cutter and ensure it is
held in place, carry this out along its full length.
Should the cutter not grip adjacent to a bench leg, adjust the foot to slightly raise that part of the
bench and test again.
Should the paper not be gripped by the cutter bar between the legs, place a levelling bracket and screw
in the beam on the underside of the base extrusion. Position it in the middle of the area that is not
clamping and tighten the screw until the paper is clamped efficiently. Check the whole cutter bar is
clamping, add more levelling brackets and adjust if necessary.
Assembly 3.5